BHP+120 hp (16%)
Standard
730 hp
Tuned
850 hp
Torque+440 Nm (12%)
Standard
3600 Nm
Tuned
4040 Nm
Suitability
Good (6.5/10)Gains Profile
Power-focusedHeadroom
MediumScania Trucks R-Series 730 ECU Remapping
Considering an ECU remap for your Scania Trucks R-Series 730? A Stage 1 remap can take this All diesel engine from 730 BHP to 850 BHP and from 3600 Nm to 4040 Nm of torque (turbocharged). This engine scores 6.5/10 for remap suitability. Get a free personalised quote from a trusted remap professional and find out exactly what your Scania Trucks R-Series can achieve.
How this engine compares
- 1stof 16 Scania Trucks R-Series engines by power gain
- 99%of the 9,842 engines we hold gain data for see a smaller power increase
- 99%of engines with torque data see a smaller torque increase
Comparisons are calculated from our own recorded Stage 1 figures.
Assessment
The Scania Trucks R-Serie 730 is a turbocharged diesel engine producing 730 BHP and 3600 Nm from the factory. With a typical Stage 1 remap, output increases to approximately 850 BHP and 4040 Nm — a gain of around 120 BHP (16%) and 440 Nm (12%).
This engine has moderate remap suitability, with gains weighted towards peak power — the improvement is most noticeable at higher RPM. The tuning headroom is classified as moderate, based on the percentage gain available from the factory output.
Considerations: High tuned torque: check transmission torque capacity and service history.
Fuel economy note: possible improvement with conservative driving.
All figures shown are typical estimates based on aggregated Stage 1 data for this engine variant. Actual results depend on vehicle condition, mileage, and the chosen tuning method. We recommend discussing your specific vehicle with a qualified remap professional.
Considerations
!High tuned torque: check transmission torque capacity and service history.
Other R-Series All Engines
| Engine | BHP | Gain | Torque |
|---|