BHP+95 hp (17%)
Standard
560 hp
Tuned
655 hp
Torque+430 Nm (16%)
Standard
2700 Nm
Tuned
3130 Nm
Suitability
Good (7/10)Gains Profile
BalancedHeadroom
MediumScania Trucks R-Series 560 ECU Remapping
Considering an ECU remap for your Scania Trucks R-Series 560? A Stage 1 remap can take this All diesel engine from 560 BHP to 655 BHP and from 2700 Nm to 3130 Nm of torque (turbocharged). This engine scores 7/10 for remap suitability. Get a free personalised quote from a trusted remap professional and find out exactly what your Scania Trucks R-Series can achieve.
How this engine compares
- 2ndof 16 Scania Trucks R-Series engines by power gain
- 98%of the 9,842 engines we hold gain data for see a smaller power increase
- 99%of engines with torque data see a smaller torque increase
Comparisons are calculated from our own recorded Stage 1 figures.
Assessment
The Scania Trucks R-Serie 560 is a turbocharged diesel engine producing 560 BHP and 2700 Nm from the factory. With a typical Stage 1 remap, output increases to approximately 655 BHP and 3130 Nm — a gain of around 95 BHP (17%) and 430 Nm (16%).
This engine has moderate remap suitability, with a balanced spread of gains across both power and torque — providing a noticeable improvement across the rev range. The tuning headroom is classified as moderate, based on the percentage gain available from the factory output.
Considerations: High tuned torque: check transmission torque capacity and service history.
Fuel economy note: possible improvement with conservative driving.
All figures shown are typical estimates based on aggregated Stage 1 data for this engine variant. Actual results depend on vehicle condition, mileage, and the chosen tuning method. We recommend discussing your specific vehicle with a qualified remap professional.
Considerations
!High tuned torque: check transmission torque capacity and service history.
Other R-Series All Engines
| Engine | BHP | Gain |
|---|