BHP+35 hp (8%)
Standard
440 hp
Tuned
475 hp
Torque+300 Nm (13%)
Standard
2300 Nm
Tuned
2600 Nm
Suitability
Good (6.5/10)Gains Profile
Torque-focusedHeadroom
MediumScania Trucks R-Series 440 ECU Remapping
Considering an ECU remap for your Scania Trucks R-Series 440? A Stage 1 remap can take this All diesel engine from 440 BHP to 475 BHP and from 2300 Nm to 2600 Nm of torque (turbocharged). This engine scores 6.5/10 for remap suitability. Get a free personalised quote from a trusted remap professional and find out exactly what your Scania Trucks R-Series can achieve.
How this engine compares
- 15thof 16 Scania Trucks R-Series engines by power gain
- 54%of the 9,842 engines we hold gain data for see a smaller power increase
- 97%of engines with torque data see a smaller torque increase
Comparisons are calculated from our own recorded Stage 1 figures.
Assessment
The Scania Trucks R-Serie 440 is a turbocharged diesel engine producing 440 BHP and 2300 Nm from the factory. With a typical Stage 1 remap, output increases to approximately 475 BHP and 2600 Nm — a gain of around 35 BHP (8%) and 300 Nm (13%).
This engine has moderate remap suitability, with gains weighted towards torque — you will notice the difference most strongly in mid-range pulling power and in-gear acceleration. The tuning headroom is classified as moderate, based on the percentage gain available from the factory output.
Considerations: High tuned torque: check transmission torque capacity and service history.
Fuel economy note: possible improvement with conservative driving.
All figures shown are typical estimates based on aggregated Stage 1 data for this engine variant. Actual results depend on vehicle condition, mileage, and the chosen tuning method. We recommend discussing your specific vehicle with a qualified remap professional.
Considerations
!High tuned torque: check transmission torque capacity and service history.
Other R-Series All Engines
| Engine | BHP | Gain |
|---|