BHP+55 hp (14%)
Standard
380 hp
Tuned
435 hp
Torque+285 Nm (15%)
Standard
1900 Nm
Tuned
2185 Nm
Suitability
Good (6.5/10)Gains Profile
BalancedHeadroom
MediumScania Trucks P-Series 380 ECU Remapping
Considering an ECU remap for your Scania Trucks P-Series 380? A Stage 1 remap can take this All diesel engine from 380 BHP to 435 BHP and from 1900 Nm to 2185 Nm of torque (turbocharged). This engine scores 6.5/10 for remap suitability. Get a free personalised quote from a trusted remap professional and find out exactly what your Scania Trucks P-Series can achieve.
How this engine compares
- 4thof 10 Scania Trucks P-Series engines by power gain
- 82%of the 9,842 engines we hold gain data for see a smaller power increase
- 97%of engines with torque data see a smaller torque increase
Comparisons are calculated from our own recorded Stage 1 figures.
Assessment
The Scania Trucks P-Serie 380 is a turbocharged diesel engine producing 380 BHP and 1900 Nm from the factory. With a typical Stage 1 remap, output increases to approximately 435 BHP and 2185 Nm — a gain of around 55 BHP (14%) and 285 Nm (15%).
This engine has moderate remap suitability, with a balanced spread of gains across both power and torque — providing a noticeable improvement across the rev range. The tuning headroom is classified as moderate, based on the percentage gain available from the factory output.
Considerations: High tuned torque: check transmission torque capacity and service history.
Fuel economy note: possible improvement with conservative driving.
All figures shown are typical estimates based on aggregated Stage 1 data for this engine variant. Actual results depend on vehicle condition, mileage, and the chosen tuning method. We recommend discussing your specific vehicle with a qualified remap professional.
Considerations
!High tuned torque: check transmission torque capacity and service history.
Other P-Series All Engines
| Engine | BHP | Gain |
|---|