BHP+29 hp (8%)
Standard
360 hp
Tuned
389 hp
Torque+250 Nm (13%)
Standard
1900 Nm
Tuned
2150 Nm
Suitability
Good (6.5/10)Gains Profile
Torque-focusedHeadroom
MediumScania Trucks P-Series 360 ECU Remapping
Considering an ECU remap for your Scania Trucks P-Series 360? A Stage 1 remap can take this All diesel engine from 360 BHP to 389 BHP and from 1900 Nm to 2150 Nm of torque (turbocharged). This engine scores 6.5/10 for remap suitability. Get a free personalised quote from a trusted remap professional and find out exactly what your Scania Trucks P-Series can achieve.
How this engine compares
- 9thof 10 Scania Trucks P-Series engines by power gain
- 38%of the 9,842 engines we hold gain data for see a smaller power increase
- 96%of engines with torque data see a smaller torque increase
Comparisons are calculated from our own recorded Stage 1 figures.
Assessment
The Scania Trucks P-Serie 360 is a turbocharged diesel engine producing 360 BHP and 1900 Nm from the factory. With a typical Stage 1 remap, output increases to approximately 389 BHP and 2150 Nm — a gain of around 29 BHP (8%) and 250 Nm (13%).
This engine has moderate remap suitability, with gains weighted towards torque — you will notice the difference most strongly in mid-range pulling power and in-gear acceleration. The tuning headroom is classified as moderate, based on the percentage gain available from the factory output.
Considerations: High tuned torque: check transmission torque capacity and service history.
Fuel economy note: possible improvement with conservative driving.
All figures shown are typical estimates based on aggregated Stage 1 data for this engine variant. Actual results depend on vehicle condition, mileage, and the chosen tuning method. We recommend discussing your specific vehicle with a qualified remap professional.
Considerations
!High tuned torque: check transmission torque capacity and service history.
Other P-Series All Engines
| Engine | BHP | Gain |
|---|