Iveco Cursor 13 - 440 - 440hp Remap
Expected gains of +80 BHP and +400 Nm torque
Get Your Free Quote ↓BHP+80 hp (18%)
Standard
440 hp
Tuned
520 hp
Torque+400 Nm (19%)
Standard
2100 Nm
Tuned
2500 Nm
Suitability
Good (7/10)Gains Profile
BalancedHeadroom
MediumIveco Cursor 13 - 440 - 440hp ECU Remapping
Considering an ECU remap for your Iveco Cursor 13 - 440 - 440hp? A Stage 1 remap can take this All diesel engine from 440 BHP to 520 BHP and from 2100 Nm to 2500 Nm of torque (turbocharged). This engine scores 7/10 for remap suitability. Get a free personalised quote from a trusted remap professional and find out exactly what your Iveco Cursor can achieve.
How this engine compares
- 1stof 10 Iveco Cursor engines by power gain
- 95%of the 9,842 engines we hold gain data for see a smaller power increase
- 99%of engines with torque data see a smaller torque increase
Comparisons are calculated from our own recorded Stage 1 figures.
Assessment
The Iveco Cursor 13 - 440 - 440hp is a turbocharged diesel engine producing 440 BHP and 2100 Nm from the factory. With a typical Stage 1 remap, output increases to approximately 520 BHP and 2500 Nm — a gain of around 80 BHP (18%) and 400 Nm (19%).
This engine has moderate remap suitability, with a balanced spread of gains across both power and torque — providing a noticeable improvement across the rev range. The tuning headroom is classified as moderate, based on the percentage gain available from the factory output.
Considerations: High tuned torque: check transmission torque capacity and service history.
Fuel economy note: possible improvement with conservative driving.
All figures shown are typical estimates based on aggregated Stage 1 data for this engine variant. Actual results depend on vehicle condition, mileage, and the chosen tuning method. We recommend discussing your specific vehicle with a qualified remap professional.
Considerations
!High tuned torque: check transmission torque capacity and service history.
Other Cursor All Engines
| Engine | BHP | Gain | Torque |
|---|