Audi Q3 40 TFSI (2.0T) 190hp Remap

The Audi Q3 40 TFSI (2.0T) 190hp is a 2.0L turbocharged petrol engine producing 190 BHP and 320 Nm from the factory. With a typical Stage 1 remap, output increases to approximately 245 BHP and 430 Nm — a gain of around 55 BHP (29%) and 110 Nm (34%).

This engine scores highly for remap suitability, with a balanced spread of gains across both power and torque — providing a noticeable improvement across the rev range. The tuning headroom is classified as high, based on the percentage gain available from the factory output.

From a technical perspective, the ECU is typically a Bosch MED17 (likely), and the transmission is manual and dsg/s tronic automatics are common depending on model/engine. some dsg/dual-clutch gearboxes have torque management; calibration may be torque-limited..

Considerations: Turbo petrol: fuel quality and cooling can influence repeatable performance.. High tuned torque: check transmission torque capacity and service history.. Large torque increase: drivetrain condition (clutch/gearbox) becomes more important at this level.

All figures shown are typical estimates based on aggregated Stage 1 data for this engine variant. Actual results depend on vehicle condition, mileage, and the chosen tuning method. We recommend discussing your specific vehicle with a qualified remap professional.